Arboria Heritage Arbor Uživatelský manuál stáhnout pdf

Heritage Arbor/Grand Entry

PLEASE READ THROUGH BEFORE STARTING ASSEMBLY

ASSEMBLY INSTRUCTIONS

YOU WILL NEED

COMPONENTS LIST

Arbor side panels (2)

Headers (2)

Braces (4)

Caps (7)

Wings (2)

Post sleeves (2)

Post Base Kit (2)

Post caps (2)

(Hardware included)

Arbor only

• 2 1/2” screws (8)

• 3 1/2” screws (22)

• 9 7/8” spacer block

• Anchor stake kit

◊ 3/4” screws (8)

◊ Anchors (4)

PRELIMINARIES

IF YOU PLAN TO PAINT

If you wish to stain or paint your arbor/entry, we recommend that you do so before assembly, this will make the product

easier to install. Be careful not to cover up guide marks on the rafters.

WORK AREA

Select an area close to where the arbor/entry will be installed. The assembly area should be relatively flat and open with

at least 8’x6’ of space. We recommend the use of the shipping box as your work surface to protect the arbor/entry

against damage during assembly.

Complete

Assembly

Components 5-8

included with

Grand Entry Only

• 2 1/2” washer head screws (8)

• #2 square head driver bit

HARDWARE PROVIDED

445.35.100 1 of 4 9/29/2006

Division of LWO Corp. / P.O. Box 17125 / 3841 North Columbia Boulevard / Portland, Oregon

503-286-5372 / fax 503-286-4092

Additional Hardware

(Included with Grand Entry)

• 5’ Pressure treated 4x4

posts (2)

• 2” Galvanized trim head

nails

• Concrete mixing tools

• Wood shims

• Wood adhesive

• Pre-mix concrete (120lb)

Additional Tools and

Supplies for Grand Entry

Tools and Supplies

for Arbor

• Phillips screwdriver

• Tape measure

• Carpenter Square

• Pre-mix concrete (120lb)

(optional)

1 2 3 4

Shrnutí obsahu

Strany 1 - Heritage Arbor/Grand Entry

Heritage Arbor/Grand Entry PLEASE READ THROUGH BEFORE STARTING ASSEMBLY ASSEMBLY INSTRUCTIONS HA YOU WILL NEED COMPONEN

Strany 2 - STEP 2: SQUARING THE ARBOR

STEP 1: ATTACHING THE SIDE PANELS TO THE HEADERS Headers are designed to allow three sizes of opening allowing you to choose the size of opening tha

Strany 3 - Diagram 1

Now that the arbor is in place, measure 33” out from the side panel post to locate the center position of the 4x4 post. Align the center of arbor pos

Strany 4

• Use shims, adhesive and finish nails or screws to secure the shims and sleeve firmly to the 4x4 post. Be sure to shim both the top and bottom of th

Komentáře k této Příručce

Žádné komentáře

Arboria Heritage Arbor Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro ne Arboria Heritage Arbor. Arboria Heritage Arbor User's Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro ne Arboria Heritage Arbor